Roper Electric 120/240-Volt Manuel d'utilisateur

INSTALLATION INSTRUCTIONS30" (76 CM) FREESTANDING ELECTRIC RANGESRANGE SAFETYTable of ContentsRANGE SAFETY ...

10Complete Installation1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.2

11ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall.Left edge

W10196158B© 2008.All rights reserved.8/08Printed in U.S.A.

2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

3Product Dimensions*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.Cabinet DimensionsCabinet opening dimensions sho

4Electrical ConnectionTo properly install your range, you must determine the type of electrical connection you will be using and follow the instructio

54. On Ranges Equipped with Storage Drawers:Remove the storage drawer. Use a ¼" drive ratchet to lower the rear leveling legs one-half turn. Use

69. Move range into its final location making sure rear leveling leg slides into anti-tip bracket.10. If installing the range in a mobile home, you mu

7Style 2: Direct wire strain relief Remove the knockout as needed for the flexible conduit connection. Assemble a UL listed conduit connector in the

83-wire connection: Power supply cordUse this method only if local codes permit connecting cabinet-ground conductor to neutral wire of power supply co

93-wire connection: Direct wireUse this method only if local codes permit connecting ground conductor to neutral supply wire.1. Loosen (do not remove)